Avital MAXX2 Installationsanleitung PDF herunterladen (Seite 3)

Important Information

IMPORTANT! The Avital Maxx

system is designed to be installed in any petrol powered vehicle with

a 12 volt battery.

One Avital Maxx

Control Unit Voltmeter

One Prewired 18-Pin Connector Harness Wire Strippers/cutters

One Prewired 10-Pin Connector Harness Electric Drill & Bits

One Prewired Valet Switch Convoluted Tubing *

One Prewired Status LED Soldering Iron

One 4-Button 10-Channel Remote Control Wire Crimpers

One 2-Button 3-Channel Remote Control Shrink Tube or Electrical Tape

Two Ultrasonic Transducers Phillips Screwdriver

One Battery Back-up Siren with Mounting Bracket

One Hardware Pack

One Owner’s Guide

One Certificate of Installation

Two Avital Window Decals * Optional

1. Test all circuits with a voltmeter.

2. Make all wiring connections using solder and heatshrink using the procedure below. Do NOT twist wires or

use scotch-lock connectors.

• Strip half an inch of insulation from the wires you are going to solder and slide a piece of shrink tubing

over one of them.

• Join the wires together, then heat the wires with a soldering iron whilst touching solder to the wires

until the solder melts.

• Pull the wires to test the solder joint, then position the loose shrink tube over the solder joint and gently

heat with a hot air gun so that it tightly seals and insulates.

3. Keep extensions as short as possible. Use the same gauge wires for short extensions and larger gauge wires

for longer extensions.

4. Before installing, discuss the placement of the LED indicator and Valet switch with the vehicle’s owner.

5. Turn off interior light(s) or remove interior light fuse to prevent battery drain.

recommended procedures

required installation toolssystem components

1 2 3 4 5 6 7 8 ... 23 24

Keine Kommentare

Avital MAXX2 Installationsanleitung Seite 3